Installation
conditions are one of the primary factors in the use of factors,
sliding bearings are often due to improper installation and lead to the
entire bearing parts of the force between the state changes, the bearing
in the abnormal state of operation and early failure. According
to the thrust ball bearing installation, use, maintenance, maintenance
of technical requirements, the operation of the SKF bearings bear the
load, speed, operating temperature, vibration, noise and lubrication
conditions to monitor and check the anomaly immediately find the reasons
to adjust To make it back to normal.
Installation
conditions are one of the primary factors in the use of factors, the
bearings are often due to improper installation and lead to the entire
bearing parts of the force between the state changes, sliding bearings
in an abnormal state of operation and early failure. According
to the sliding bearing installation, use, maintenance, maintenance of
the technical requirements of the running SKF bearings bear the load,
speed, operating temperature, vibration, noise and lubrication
conditions to monitor and check the anomaly immediately find the reasons
for the adjustment, Make it back to normal. SKF bearings break off the secondary reason is the lack of overload to take two voxels. When the external load spans the material strength limit and the formation of part breaks is called overload fracture. The reason for the overload is that the machine is getting faulty or incorrectly. Bearing
parts of the micro-cracks, shrinkage, bubbles, large foreign matter,
superheated tissue and local burns and other defects are impact overload
or violent vibration will be caused by defects at the fault, known as
defective fracture. It
should be noted that the sliding bearing is in the process of
manufacturing, the material into the factory re-inspection, casting and
heat treatment of the amount of control, processing can be precisely
through the instrument to elucidate the above-mentioned defects can be
no, after the need to strengthen the control. But in general, all the sudden fall of the bearings are mostly overloaded.
SKF
bearings are working outside, due to outside or inside the elements of
the impact, so that there is no common gap changes, the accuracy of the
reduction, and even the formation of "killed" called the gap change
effect. External
factors such as the deficit is too large, not in place, the temperature
rise caused by the amount of expansion, instantaneous overload, etc.,
elements such as broken austenite and broken forces in the non-chaos,
etc. are the formation of gap changes The secondary reason for failure.
CATEGORIES
Latest news
- Ferrofluid Vacuum Feedthrough Seals us
- Dry Bearing Bush
- Ball transfer unit
- Motorcycle suspension bushing
- Bimetal Flange Bush Bearing
- Selection standard for dimension refer
Contact us
- ADD: No.503,Hunan International Commerce Center, Jintai Square,Changsha 410001,Hunan.
- TEL: +86 731 84770165
- FAX: +86 731 84770163
- E-mail: sales3@slide-bearing.com
> Company News